Installation Guide: https://bit.ly/PanzerV3-Rev00

This is an upgrade kit for the Thrustmaster TWCS throttle to improve smoothness and feel and reduce resistance. The original mod was inspired by CoreHawk3D but with my own twist on the concept. Now, this is the next evolution of the mod which addresses specific opportunities for improvement that was present in the original version of my mod.

Here is a list of features:
- (New) Supports a multitude of bearing options ( 2x LM8LUU / 4x Polymer LM8UU / Hybrid - 2x Polymer + 2x LM8LUU )
- (New) Shield (Pressure Plate) better securely holds the bearings and increases rigidity under torsional and upward negative forces
- (New) Triangular bearing housing better maintains alignment under very heavy downward forces.
- (New) TPU Grip Pads to eliminate play between the throttle stem and the slider.
- (New) V3 - Quick Install Detent System - utilizing 2 neodymium magnet pairs (4mm Dia x 2mm Thick) to achieve a detent that is crisp and non-mushy.

V3 - Quick Install Detent:
- Uses a new locking detent system for easy detent installation and reinstallation to different locations.
- Uses non-uniform spacing between percentages that are precisely geometrically calculated to compensate for the non-uniform percentage increments for distance traveled at various detent locations.
- Expected percentage deviation is less than 1% if Ramps are installed properly

- Config 1 - Uses 2PCS of the 10's Ramp
--- Double Detent Strength by allowing for 2 magnet pairs (one on each side)
--- Supports (0% / 10% / 20% / 30% / 40% / 50% / 60% / 70% / 80% / 90% / 100%)

- Config 2 - Uses 1PC - 5's Ramp / 1PC - 10's Ramp
--- Supports (0% / 5% / 10% / 15% / 20% / 25% / 30% / 35% / 40% / 45% / 50% / 55% / 60% / 65% / 70% / 75% / 80% / 85% / 90% / 95% / 100%)

IMPORTANT NOTE:
- Because of the space requirements needed to implement the V3 detent system, compatibility with previous versions of the slider is not possible. As such I will not be making the new detent system available for purchase separately for previous customers.

Everything needed to install is included in the kit.

Color Options:
- Orange
- Grey

Included:
- 1PC - Slider Body
- 1PC - Pressure Plate
- 1PC - TPU Grip Pad
- 6PCS - Detent Magnets
- 2PCS - 10's Detent Ramp
- 1PC - 5's Detent Ramp
- 1PC - Detent Ramp Locating Tool
- Linear Bearings (2PC-LM8LUU / 4PC-Polymer / Combination Bearings) - Installed on the Slider

Installation Guide:
- https://bit.ly/PanzerV3-Rev00