Fishing Rod Holder for Trucks - Several Versions

You will need to choose the option you want from the dropdown.

This fishing rod/pole holder designed to fit most truck beds. It clamps on the bottom lip at the top of the bed. This way it will not interfere with most toppers and does not clamp on the top edge of the bed where it could easily be seen or have other hardware. Neoprene rubber is added to prevent the clamp from sliding and helps lock it in place. It will accommodate different thicknesses so toppers or tonneau cover hardware is not an issue.

This fits the adjustable style rod holders and tool holders. They come in different sizes so you can choose what best fits your needs. If you do not see an option you want, please message me. Most times, I can add new options or design a custom version for you.

The bolt and nut are 18-8 stainless steel. All other parts are 3D printed out of PETG so it can withstand the heat and UV rays.

1. Half sets are for customers that want to mix and match their own set or want to update/change a previous setup. Note, you need 1 holder for each end of the rod to properly hold it.
2. The height is adjustable so you can make them go above or below the bed. This works great so you can have the rods at an angle so you can close the truck bed and still fit long rods.
3. Non-circle holders come with a bungee to hold the rods from falling out.
4. Circle Holders do not use a bungee and hold one end of the rod. This makes it easier to install and remove the rod without needing to climb in the bed or hang over the side to remove a bungee like the In-Bed version. This is a great option for customers with a tonneau cover or topper.

This is generic to fit most trucks, but please check the pictures and your style truck bed before ordering.

Custom or modified options are available upon request. Message me so we can discuss.